Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2021 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

found a 'loose' RTA bushing shell while installing poly bushings - anyone else seen this? 200

uid 17010's pic
posted by  tvg on  Mon Oct 18 15:13 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 21 14:10 CST 2007
[RELATED]

I had burned out the rubber in the passenger side rear trailing arm bushing and was pressing in the poly bushing when I noticed that the shell was shifting. It turned out that there was play between the bushing shell and the mounting ears on the axle. It looked like there was a gap large enough to fit a small nail. I considered doing just that to shim it up, but then remembered my tailpipe expander tool. So I expanded the shell as much as I could and it seemed pretty snug, although with torque I could still get it to spin. I put it all back together with the new poly bushings, but I fear it will loosen, start to clunk and then I'll have to get back under there and do a re-install with a new shell. Any thoughts? Similar experience?

Thanks,
Tom
'86 240 DL wagon 233k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New found a 'loose' RTA bushing shell while installing poly bushings - anyone else seen this? [200]
posted by  tvg  on Mon Oct 18 15:13 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.