Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel Level Sending Unit replacement and Fuel hose sizes 200 1985

posted by  Antiriad on  Fri Aug 13 05:18 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 27 09:36 CST 2011
[RELATED]

Guys

About a year ago I replaced my intank fuel pump in my 85' 240. I have made up a special key for removing the retaining ring but it is just a pain trying to remove these old hoses. Anyways, last time I replaced the Intank pump unit it seems that the fuel sending sensor got out of range and as a result when I fill the gas tank full the fuel level drops all the way to 0(out of range) after a couple of miles on the full tank the fuel sender returns to normal full levels and then it drops at 3/4 of the tank(gap). I was thinking that I might go ahead and replace the fuel hoses that get to the fuel tank. They have become quite old and hardened. It will also be a good opportunity to replace the fuel sending unit with either a junkyard unit or with a new unit.

Since a new unit cost from $100-130 I was thinking of going for a used junkyard unit.

Can I use a sending units from 240 up to 1993?


In addition what are the hose sizes I need to replace?

Any other ideas?

Thanks

Michael






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel Level Sending Unit replacement and Fuel hose sizes [200][1985]
posted by  Antiriad  on Fri Aug 13 05:18 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.