Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2009 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

940 turbo won't crank/start after hot soak. 900

posted by  someone claiming to be Desperate for No Start/ Hot Soak solution on  Tue Mar 30 14:53 CST 2004 [RELATED]

My 1994 940 turbo won't start after hot soaks. Engine won't turn, dashboard lights, and the fuel pump turns on when the key is turned but no attempt to crank at all until after 30-60 minutes has past. The fuel pump relay, spark plugs, wires, distributor cap/rotor, power stage, radio suppression relay, coil, and crank sensor have all been replaced since the problem began to occur. The system ground and wire connectors for the crank sensor, IAC, temperature sensors and all the other relays previously mentioned have all been cleaned/greased and the #1 fuse has been replaced. 1 response that I received earlier suggested that the fuel pump relay be resoldered. Does that need to be done if the relay has been replaced? I'm taking any suggestions at this point. HELP!!!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 940 turbo won't crank/start after hot soak. [900]
posted by  someone claiming to be Desperate for No Start/ Hot Soak solution  on Tue Mar 30 14:53 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.