Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

wrench size for O2 sensor 200 1989

posted by  interstition on  Sat Nov 22 12:46 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Apr 28 10:13 CST 2014
[RELATED]

Fault codes tell me Oxygen sensor on my '89 240, 132K miles. I want to try taking it out and cleaning it because hope springs eternal. Besides wanting $200 for a new one, local parts dealer says ALL O2 sensors are 7/8 inch and I should buy his removal socket. I tried my SAE crescent wrenches and 7/8 seems just a little too big, and 13/16 too small. I Don't have metric crescents (yet) and I don't want to strip it, so presuming it's original, does anyone know what size wrench is right ? 21mm ? Any advice on removing and possibly restoring this sensor ? I will buy one from Groton if I must. Thanks.

Andy - 89 240 132Kmi, 91 740 182Kmi, (87 240 225Kmi lost the rust battle).






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New wrench size for O2 sensor [200][1989]
posted by  interstition  on Sat Nov 22 12:46 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.