Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

86 240 won't start, air mass meter? 200

Hello- I am hoping for some quick advice before I have her towed to the shop. . . My car was running fine. . . .it sat for a few hours and then would/will not start. The motor turns over fine and even runs for a split second but immediatately stalls. This can be repeated over and over again. There is fuel in the tank, fuel pump is humming and all four plugs produce spark. The plugs do look a bit dark upon removal. Also I do smell a bit of gas in the cylinders There are no obvious problems with the intake tract. I performed the electrical tests for the LH 2.2 as described in the Bentley manual and came up with two anomolies. The airmass meter's "heated wire" resistance was 2.9 ohms instead of the 3.5-4.0 range specified in the manual. Also the red wire (#16) on the computer connector that hooks up to the AC mircoswitch always reads continuity to ground rather than the books spec which is no continuity with the AC switched off and variable (As you turn the knob) resistance with the AC switched on. I am more suspicious of the Airmass meter than the ACmircoswitch but who knows. Any thoughts would be greatly appreciated






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 86 240 won't start, air mass meter? [200]
posted by  Urb  on Sat Jul 5 09:25 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.