Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Changing rear springs on a 1986 244 200 1986

posted by  B.C. on  Thu May 22 18:57 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 28 22:28 CST 2012
[RELATED]

Hello -

I am going to be using a trailer soon, and I have on hand a set of rear springs from a wagon. I will be installing the trailer hitch Friday, and it occurs to me that putting in the wagon springs would be a good idea.

AFAIK the springs are held in by compression and a bolted plate in the bottom of the coil. So, my question is this - can the spring swap be done by removing that bolted plate and then using a spring compressor to remove the spring?? That would save the work required to unhook the shock absorbers, since I am not planning to replace the shocks at this time.

Thanks,

Bob

:>)





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Changing rear springs on a 1986 244 [200][1986]
posted by  B.C. subscriber  on Thu May 22 18:57 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.