Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to remove fan/fan clutch? 200 1979

posted by  244_DL on  Mon Apr 28 09:06 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

------The fan on my brick is a little loose and makes a rubbing or griding noise from inside, does this mean my water pump may be damaged or does this just have to do with the fan/fan clutch?
------So now I need to remove my fan and fan clutch and I am perplexed at how this is done. There is a large bolt right in the middle of the fan (I have the old metal blade fan) and when i turn this the entire engine turns so this is wrong. I noticed that there are four smaller bolts on the back but I can not get to them because it is such a small area. I am sure that someone had to remove the fan and came across this small problem.
------I am also wondering if I can switch to the plastic bladed "flexi-fan" without any problems? Also I was thinking about just putting an electric fan on and if there was a kit or something for this.
--Thanks for any advise.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to remove fan/fan clutch? [200][1979]
posted by  244_DL  on Mon Apr 28 09:06 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.