Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Sealing replacement windshield wiper motor 200 84

posted by  someone claiming to be Zee on  Sun Dec 17 23:57 CST 2000 [RELATED]

It has been more than a year since I removed the bad wiper motor and replaced it with a used one. Trouble is, I forgot how the original was sealed up against water leaking into the passenger side. (which it does)

On my '86, it looks like there is a spongy, black sealant under the motor to seal up the shaft hole.

Is this the only area that needs this caulking?

How about the hole inside the cowling where the shaft comes through to attatch to the wiper mechanism? Is this a second place for water to leak inside?

Finally, what are we using as sealant? I have some rope caulk (buytl-rubber)





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Sealing replacement windshield wiper motor [200][84]
posted by  someone claiming to be Zee  on Sun Dec 17 23:57 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.