Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 3/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Cleaned Flame Trap - Still Jiggling? 200 1992

posted by  someone claiming to be Tom on  Sat Dec 2 15:49 CST 2000 [RELATED]

With a diagram and instructions from the FAQ, I set out this afternoon to inspect and clean the flame trap on my newly purchased 1992 240 station wagon. After about 20 miutes I finally deducted the location of the flame trap and the three hoses that fit to it. It took some wiggling and stretching, but I was able to get all the hoses off and the hard plastic spaghetti strainer part out of the trap. I cleaned everything out (the hoses weren't very clogged) and re-installed everything. Excitedly, I started the engine to do the jiggle test. I unscrewed the oil fill cap and much to my dismay, there was jiggling! I pushed down and pulled up on the cap and I did feel negative pressure pulling down slightly on the cap. Is everything ok or is some jiggling normal? Any suggestions on what else could be going wrong?

Also, where is the PCV valve located?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Cleaned Flame Trap - Still Jiggling? [200][1992]
posted by  someone claiming to be Tom  on Sat Dec 2 15:49 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.