Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 12/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

third seat install question... 200 all

posted by  someone claiming to be Bill D. on  Fri Nov 10 03:17 CST 2000 [RELATED]

I just bought a 3rd seat for a 245 at the wreckers with all the hardware tht I plan to sell on ebay. My question is how critical is the hole location in the wheel well for the lower seatbelt mount bolt? I measured and can get close but the metal does not seem to be reinforced so it looks like as long as the hole stays in front of the radial ridge pressed into the metal it should be fine. Also the torque seems light on the bolts since they came out with just 6 inch cresent wrench with no problem. Any ideas on the bolt torque? I guess they are in shear not tensionso the torque is not really important?

Bill D.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New third seat install question... [200][all]
posted by  someone claiming to be Bill D.  on Fri Nov 10 03:17 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.