Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2023 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1992 Volvo Hi/Lo Beam Wiring 200 1992

posted by  someone claiming to be VolvoJoe on  Tue Aug 3 15:17 CST 2021 [RELATED]

I need some help. I was replacing the Stalk with Hi/Lo Headlights, Turn Signals, and Cruise Control as the Cruise Buttons seemed intermittent. When I was pulling on the two cables to see where they plug into the Harness, the cable with the Black/White Wire and the Red/Blue Wire came unplugged. I cannot find where it plugs in. Of course looking at the electrical diagrams is murky between the small fuzzy print and the way Volvo did the prints. And maybe my old eyes... And maybe because I don't see a Red/Blue Wire. What does not work is the Hi/Lo Beam Switch. It seems that I am stuck on Lo Beams. Does anyone have a clue where to look? It has to be under the drivers side dash. Not sure how to post a picture of the Cable and Connector that pulled loose.

Thanks in advance...

-VolvoJoe






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1992 Volvo Hi/Lo Beam Wiring [200][1992]
posted by  someone claiming to be VolvoJoe  on Tue Aug 3 15:17 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.