Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

stalling issues - poor idle adjustment? 200 1988

posted by  bent on  Fri Jul 26 23:16 CST 2019
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hi all,

I have been dealing with some stalling issues. The symptoms right now are that it stalls if I put it into drive AND if I push the gas down too quickly (when in neutral). Earlier today, I got around to cleaning out the throttle body and replacing the gasket. I haven't adjusted the idle, as I do not have all the tools I need yet.

When I was cleaning the throttle body (it was very very dirty and the old gasket was in pieces), I noticed that one of the side screws was missing on this thing:

https://imgur.com/MW6QWWH

Is that going to cause me problems? Anyone know what to do in terms of replacing that?

Things I have done so far:
-replace spark plugs, distributor cap, rotor, cables.
-clean IAC.
-clean throttle body and replace gasket.
-replace air intake hose.
-clean MAF.
-replaced fuses.
-replaced fuel pump relay.

Bonus Q: I noticed that the trim below the doors is gone on the right side. Is my best bet just going to a junkyard?

Thank you all very much so far!







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New stalling issues - poor idle adjustment? [200][1988]
posted by  bent  on Fri Jul 26 23:16 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.