I flushed the coolant, replaced radiator hoses and thermostat (though it's a Murray brand w/o the bleeder pin thing), I also put on the jumper wire between pins 1 & 3 where the temp compensator board was installed.
Once warmed up, within 7 to 10 min, the temp gauge is at 10:00, just below the red.
I'm assuming this is not normal correct?
Once I get the car back tonight I'll check the wire to temp sensor.
Is there a way to check the water pump?
The upper radiator hose gets very hot, lower hose hot at pump and eventually gets warm at radiator.
I believe it's getting flow through radiator so am wondering about the pump.
Thanks for your insights.
Mike
|