Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

First-Time- Timing Belt- TDC/Distributor Misalignment? 200 1982

posted by  zeeko on  Thu Mar 1 15:54 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Mar 28 10:03 CST 2014
[RELATED]

Hey all-

I'm going through my first timing belt/tensioner/water pump change ever on my 245 with LH1.0 (chrysler white cap) and came across a couple questions:

1. TDC location- It seems a bit tricky to really be sure where TDC is. I have all 3 points on the engine/rear cover aligned with the correct ticks on the cam/crank/aux shafts, the rotor is pointing to one...ish, and when I open the oil cap and shine a light at the first two valves, they are pointing in opposite directions- one is pointing at the drivers side and one at the passenger side. Can someone verify that I have TDC correct?

2. Turning-engine-on nervousness- I'm a bit nervous to turn the engine on as I could have done something wrong. Can I test things out for a few seconds with the alt/ac belt off? If I didn't do a very good timing belt job, what's the worst thing that could happen?

3. Distributor misalignment? Okay, I DID turn my engine on for about 3 seconds. It didn't sound horrible, but not as good as it did before (perhaps having the alt disconnected affects things?) , so I went back and checked my work, this time taking the dist. cap / impulse sensor plate off in hopes that there was a TICK mark on the distributor base similar to the bosch distributor. Of course there isn't, but it seems that the 'plug wire hole' on the dist cap makes a near perfect line with the bottom nut on the thermostat housing.

When I turn everything to TDC with all tick marks aligned, the rotor is pointing BEYOND the 1st spot on the distributor cap- it's pointing between 1 and 3, but if it was pointing at 1, it would be almost pointing exactly at the bottom nut on the thermostat housing. I also know that there is a 12 +/- 2 degree timing setting for this vehicle- I don't quite understand how that comes into play as I'm a first timer, but do I ignore everything, make sure the belt and ticks are at the right and deal with the timing (I'm assuming this means rotating the distributor) afterwards?

I snapped a few photos of the areas in question at this link:

https://imgur.com/a/oNDfu





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New First-Time- Timing Belt- TDC/Distributor Misalignment? [200][1982]
posted by  zeeko  on Thu Mar 1 15:54 CST 2018 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.