Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2010 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

740 Rear end swap, dead speedo 700

replaced the failing 4.10 ABS rear end in my '92 740.
Donor car was '86 3.73 no ABS.
Before the replacement surgery the speedo would function at times, not function at times, or bounce all over the place.
After the replacement, there is NO speedo function. The connectors were different (inside of the vehicle area) from the '86 to '92, so I retained the '92 wiring.
I am not getting an ABS error.

Also, the e-brake cable seems to have shrunk by a few inches, have I possibly changed the routing of the cable?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 740 Rear end swap, dead speedo [700]
posted by  tbradstr  on Fri May 19 09:59 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.