Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2007

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

lifter tightness?

posted by  greezy on  Fri Feb 17 21:07 CST 2017
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 4 21:21 CST 2011
[RELATED]

Hello. I am assembling a B20, and I would like to know a method of gauging whether the lifters are a proper fit in their bores.

I am following the Vclassics excellent instructions for this engine work. If I coat the lifters with STP/oil (a 50/50 mix as per the guide) then none of them will drop through the bore by their own weight. I am guessing that this test is affected by temperature and it's in the 40's in my work space. If I clean bores and lifters with a degreaser and then lacquer thinner, the naked lifters drop straight down, ke-chunk.

Will a coating of 30-wt tell me if they have good enough clearance?

Any ideas? TIA, greez






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New lifter tightness?
posted by  greezy subscriber  on Fri Feb 17 21:07 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.