Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2007

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

86 240 ND alt upgrade

posted by  volvoman1980 on  Sat Sep 24 05:16 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jun 3 17:26 CST 2014
[RELATED]

Greetings all,

I have a couple ??? Regarding an alternator upgrade on my 1986 240.

I FINALLY got fed up with the remanned alts after exchanging TWO Bosch types due to misclocking of the rear half(terminal locations) got a refund and bought a
Nippondenso 80 amp alt from the Ol fleabay.
Bolted in perfectly with two exceptions.
One is the stock adjusting bracket seems to be a tad short leaving the belts quite loose. How would I remedy this situation? Is the bushing in the block simply bad? I know the adjuster is loose per say on the engine side but the Bosch doesn't have issues with this.

Two:
What's the best way to extend the b+ cable is say about 6" if that. It does fit as is but seems like I'd have to cut the protective sheath covering the wires to get the OP wire back on.

Any suggestions especially regarding the bracket will be greatly appreciated as I'm at wits end with the thing.

They are supposedly drop in upgrades. What am I missing here???

Geoff






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 86 240 ND alt upgrade
posted by  volvoman1980  on Sat Sep 24 05:16 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.