Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

re: 87 245 auto - questions regarding the tail shaft bushing and the center support bearing 200 1987

posted by  Swedish Baklava on  Tue Jan 14 21:08 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 06:40 CST 2014
[RELATED]

Hi all,

1. When removing the tail shaft from the transmission, do I need to mark it in relation to the shaft housing just like the rear/drive shaft flange?

2. To press in new tail shaft bushing, what's the best homemade tool? PVC pipe with a cap?

3. Does the tail shaft bushing has a draft anlge like the rear trailing arm bushing? Is there a certain direction I need to press in/out?

4. When tapping a new center support bearing in place, using Art Benstein's method, Can this be done by one person? Or do I need a second person either hold the shaft or homemade press tool? Do I just hold the shaft and homemade press tool at the same time?

Thank you as always.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New re: 87 245 auto - questions regarding the tail shaft bushing and the center support bearing [200][1987]
posted by  Swedish Baklava  on Tue Jan 14 21:08 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.