Volvo RWD 700 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 4/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Request for Machinist in San Diego and possible valve issue? 700 1992

posted by  Klaus Ultima on  Sun Nov 24 22:20 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jun 18 15:19 CST 2014
[RELATED]

I'm hoping to find a machinist referral to a shop that is experienced with Volvo's in the San Diego/Southern California area.

While beginning an exhaust system replacement I sheared a manifold stud. The stud that sheared was at the #4 cylinder exhaust port.

The two links, which I hope are formatted properly, show the head and the cylinder. It is clear that the environment in the #4 cylinder is different then the other 3 cylinders.

In addition to a referral of a machinist that not only can extract the sheared stud but also has the ability to replace valves if needed, I'm looking for input into what might be happening.




Thank you for your input!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Request for Machinist in San Diego and possible valve issue? [700][1992]
posted by  Klaus Ultima  on Sun Nov 24 22:20 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.