Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

intermittant no start, then limp mode, then starts 200 1993

posted by  robbmcc on  Mon May 20 12:28 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 08:41 CST 2014
[RELATED]

Read alot of posts but nothing exactly like this so I'm hoping somebody might throw me some clues. LH 2.4. Have had an intermittant no start and both recent times the same sequence got it started. Happened this morning. First verified no power was at fuse 4 with the key on. Then swapped in what I think is a good FPRelay. Still no start. Then here's the same sequence that happened both times: I upplugged the AMM and it started and ran in the terrible limp mode. Turned it off plugged the AMM back in and it started right up like nothing happened. Turned off a few times and all times started up. So what's going on? I burnished the male side of the contacts on the AMM side - didn't mess with the female on the plug side yet. Is this consistent with a bad AMM? I have 2 on the shelf that are probably good but because of the intermittant nature it might take a while to know. Any ideas out there?
Robb McC






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New intermittant no start, then limp mode, then starts [200][1993]
posted by  robbmcc  on Mon May 20 12:28 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.