Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Can't remove rusty gear shifter pin to the transmission M47 200

posted by  lhealey on  Sat Oct 13 18:44 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jul 25 14:29 CST 2013
[RELATED]

I'm trying to drop the transmission in my 93 245 because I have to replace the noisy throwout bearing. I have successfully done everything from removing the two 18mm bolts from the top of the bellhousing to dropping the driveshaft.

HOWEVER, I cannot get the pin that links the shifter lever to the shift arm on the transmission to budge. I removed the rusty allen head screw that holds it in place, but it's rusted around the shifter shaft.

Any tips on how to get it out? I've been soaking it in AeroKroil all day and no luck. Tried grabbing one end sticking out with vice grips, but no luck there. Not enough meat to grab hold of.


And just an aside, why do you have to remove the gear shift lever to drop the transmission? After you free the pin from the shifter/transmission shift arm why would you need to pull the shifter up and out of the car?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Can't remove rusty gear shifter pin to the transmission M47 [200]
posted by  lhealey  on Sat Oct 13 18:44 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.