Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

OD Guru - need some o-rings 200 1983

posted by  gt6 on  Fri Apr 27 21:07 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jul 17 19:44 CST 2013
[RELATED]

Paging OD guru... don't know your current email.

I had to rebuild my solenoid; after 20+ years of flawless service, the o-rings had worn to the point that fluid was seeping back into the coil cavity, causing auto-engagement when coasting in gear. I disassembled and cleaned everything, then popped on some new o-rings from Harbor Freight. Well, they don't seem to be *quite* the right sizes, despite what the specs say. I gave it the old college try, but the new rings on the piston were clearly too loose and let fluid past.

Do you have an o-ring kit in stock?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New OD Guru - need some o-rings [200][1983]
posted by  gt6  on Fri Apr 27 21:07 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.