Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2014 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

need help testing fuel sender w/resistor 900

posted by  hardknocks! on  Fri Nov 26 09:56 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 12 06:42 CST 2014
[RELATED]

hello
car is 94 940T
info from FAQ
(Diagnosis. To isolate the fault, obtain a 68-ohm resistor. Disconnect battery negative, insert the resistor between the sender connector near the tank and ground, reconnect battery negative, and turn on the ignition. The gauge should read the value noted. If it does, then your sensor of faulty. If it does not, then your fault is in the wiring from the tank to the gauge, the gauge itself.

im not sure exactly where to connect the resistor as i am not so good at this type of thing.
i understand the concept but there are two wires going to sender rod/coils.
if anyone can explain this in detail it would be great.
thanks
Mike






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New need help testing fuel sender w/resistor [900]
posted by  hardknocks! subscriber  on Fri Nov 26 09:56 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.