Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2014 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Replace Receiver/Dryer when converting to R12A 700

posted by  RobCooper on  Fri Aug 13 11:17 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 13 17:31 CST 2014
[RELATED]

I was going to do the full R134A conversion per the FAQ files, which says to get the Volvo kit and install a new receiver/dryer.

But after snooping around, this R12A seems the way to good (do not need to change the mineral oil).

So the ? is, do I still need to swap out a new receive/dryer?

If all I need to do is: recovery R12 - change the R12A fill fitting - evacuate - then fill with R12A based on pound conversion. Then this is easy!

The reason for doing this all is my high pressure hose from compressor to condenser is leaking thru pin holes in the rubber (slow leak that gets me thru summer). I will install a new hose.

Almost thru summer here in Sacramento.

thanks all






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replace Receiver/Dryer when converting to R12A [700]
posted by  RobCooper  on Fri Aug 13 11:17 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.