Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2024

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Completely Rebuilding A/C System - How to Test Compressor?

posted by  Brennan on  Mon Jun 28 18:21 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 23 10:35 CST 2014
[RELATED]

I know very little about the a/c system, but I've been reading the FAQs and doing some online research, and yesterday I took most of the a/c components out of my 1993 940 turbo, in preparation for a complete rebuild of the system.

Here's the story: A few years ago, I noticed that the hose from the evaporator to the compressor had blown apart at the fitting. I removed it and took off the belt. I drove the car for a couple of years with the compressor disconnected, and the a/c system 'open' . (Bad idea, I now know...)

When I looked at the Orifice Tube yesterday, it was clogged with some black stuff. Maybe this caused the hose to "pop"?

The compressor pulley spins freely, so is there any chance the compressor is still good? And how do I test that?







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Completely Rebuilding A/C System - How to Test Compressor?
posted by  Brennan  on Mon Jun 28 18:21 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.