Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

U joints started squeaking: need tips for replacing 200 1993

posted by  Cabbie on  Fri Jun 18 13:14 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 2 15:54 CST 2014
[RELATED]

'93 245 w/ 212k miles...

I've heard how getting the driveshaft back on the EXACT same way is critical (to ensure balance is correct)...and I intend on using white-out or something to help me capture the spline alignments before disassembly. Do you have any advice for getting all three joints off in a fast way? (once the shaft is removed) Do you put on the grease fitting before re-installing the shaft? or do you have to wait to add the grease once the shaft is back in? Any other experience shared is much appreciated. thanks,

cabbie






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New U joints started squeaking: need tips for replacing [200][1993]
posted by  Cabbie  on Fri Jun 18 13:14 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.