Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replace rear (at axle) trailing arm bushings - hard? 200

posted by  jon_h on  Mon Dec 28 17:18 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:57 CST 2014
[RELATED]

These are the bushings in the U welded to the axle. Need to replace on an 87 sedan.

Unbolt one arm, remove the old, clean & grease the U, press/ drive the new one in, re-attach. Anything else to it?

I read through several threads in the archives and it looks like folks have a lot of trouble with these. Are the new ones such a tight fit that it takes serious pressure to get them in?
--
240s: 2 drivers and some parts cars






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replace rear (at axle) trailing arm bushings - hard? [200]
posted by  jon_h  on Mon Dec 28 17:18 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.