Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replace rear (at axle) trailing arm bushings - hard? 200

posted by  Mark Lundell on  Tue Dec 29 05:50 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 14 21:34 CST 2014
[RELATED]

If you have an electric grinder (not a dremmel) with a small cutting wheel to slice the side of the old one before you try to remove it. This makes the metal casing around the bushing a bit smaller and takes the pressure off. Comes out easily after the initial little movement. Make the tool to push the new one in.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replace rear (at axle) trailing arm bushings - hard? [200]
posted by  jon_h  on Mon Dec 28 17:18 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.