Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Replace one-wire O2 sensor with heated sensor? 200 1984

posted by  Lord Volvo on  Mon Sep 28 06:37 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 4 15:55 CST 2014
[RELATED]

Me thinks it's time to replace my O2 sensor. Mine is a one-wire sensor. Would it make any sense to install a three-wire sensor assuming that it will send more accurate readings sooner than an unheated one? How would the two-wires for the heater be installed? Would it confuse the ECU or are the sensors the same other than the heater?
--
Mike F - 1984 244 DL - 285,000 miles
Original engine, transmission, drive train, starter
Undergoing reconstructive surgery with POR-15






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replace one-wire O2 sensor with heated sensor? [200][1984]
posted by  Lord Volvo subscriber  on Mon Sep 28 06:37 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.