Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Driveshaft loathing and self doubt 200

I have been chasing a driveline vibration for a week that has me batty. It was very slight, barely noticeable originally, but I'm so anal. Found the center bearing carrier badly torn. Changed it and the vibration got much worse--only on takeoff at about 5 mph. I pulled the shaft, found the front joint binding in one direction and the rear one a little rough. Middle joint was perfect, smooth and solid. I hate doing U-joints so I took it to a shop. They swapped in the joints and found the shaft out of balance. All back together tonight as the wind is howling, but absolutely nothing has changed. Obviously something about the height of the center of the shaft changed when I changed the support. Bushings out back are in more than good shape. What could I have missed? No leaks at the back of the trans--it's dry and the mount isn't squished. I did the tail shaft bushing some time ago and there is zero slop. Wish I could shim the center bearing! Suggestions bricksters?
Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveshaft loathing and self doubt [200]
posted by  David Samuels subscriber  on Tue Mar 3 14:32 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.