Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2021

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

B20 intake & exhaust manifold height differences

posted by  Duck on  Sun Apr 6 15:52 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Apr 30 21:00 CST 2014
[RELATED]

I'm going to use an early aluminum intake manifold that accepts Su HS6 carbs and a late B20 chopped in half exhaust manifold. There are 2 different heights when placed against the head. The aluminum intake manifold is lower than the cast iron exhaust manifold by about 1/4". What is a good way to fill this gap? With a spacer? Otherwise you would need to aluminum weld something on that intake, which would be quite $$$.
What say you?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B20 intake & exhaust manifold height differences
posted by  Duck  on Sun Apr 6 15:52 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.