Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2018 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hall sensor question 900 1995

posted by  someone claiming to be riverol on  Mon Apr 24 11:55 CST 2006 [RELATED]

The plastic male connector body for the Hall (exhaust camshaft position) sensor on my 1995 960 desintegrated. So I now have (red, light green and black) wires with spades to connect to the female connector with its red, blue/yellow and green/grey wires. Please, does anyone know which sensor wire connects with each female connector wire? On the females connector, the center wire is red with blue/yellow and green/gray wires on either side. I will not get a new sensor here for a few days I already tried, unsuccessfully, to get to the two Torx bolts on the sensor in the car. Thank you for your help.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hall sensor question [900][1995]
posted by  someone claiming to be riverol  on Mon Apr 24 11:55 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.