Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2020 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

problem with wiring to fuel sensor 200 1992

posted by  someone claiming to be Richard O' on  Tue Nov 29 23:52 CST 2005 [RELATED]

calling all brickboarders , what to do to repair broken wire to fuel tank. i was getting on again /off again use of the fuel guage,and when i uncovered the the plate i found the wires were rusted as they pass through a seal going into the tank. there are some tabs left ,can new wire be soldered to these??? or replace the sending unit with a new cable assembly??? thanks in advance






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New problem with wiring to fuel sensor [200][1992]
posted by  someone claiming to be Richard O'  on Tue Nov 29 23:52 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.