Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2005 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1993 940 Low Coolant Level Sensor Hook-up 900

Dear Fellow Brickboarders,

May this find you well. In the FAQs, it states, "In the 1992-1995 940, this is position 5 or 9 on the connector which connects to the unused "High Engine Temperature" lamp. Check your wiring diagram."

I have the wiring diagram for the 1993 940. Unfortunately, the position used by the low coolant indicator lamp - the lamp is between the speedometer and the tachometer (Position No. 10/81) - is not included in the wiring diagram (see Page 116-7). The likely reason is that this sensor was not installed on 940 series cars.

Does anyone know the specific position on the 12-pin connector (designated 5/1B on the wiring diagram), to which the wire from the coolant overflow tank sensor should be inserted? Positions 5,9, and 11 are available.

Having the specific location will minimize wear-and-tear on the connector, arising from the "hit and miss" connector method.

The FAQs should be updated, with the specific location, into which the connector should be inserted.

Thanks for your help. I appreciate it.

Yours faithfully,

spook






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1993 940 Low Coolant Level Sensor Hook-up [900]
posted by  spook  on Thu Sep 15 13:35 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.