Volvo RWD 120-130 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 4/2004 120-130 INDEX

[<<] [>>]

THREADED

THREADED EXPANDED

FLAT

PRINT ALL

MESSAGES IN THIS THREAD

REPLY TO THIS MESSAGE

SAVE

right angle drive part 120-130

posted by Danny on Wed Apr 20 02:40 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS]

[IGNORE ALL POSTS]

last visit: Mon Oct 6 22:01 CST 2014

[RELATED]

My good fortune to receive from a friend offloading Volvo stuff, a right angle drive, something I've wanted for awhile to get the speedo cable away from the exhaust system.
Problem is that it's missing a (pressed in?) cap. It looks as thought this cap also backs up and centers the end of the gear/shaft. How to describe this?(on CVI downloadable catalog - page 32, PN 666756). 2 shafts at right angles: longer shaft has female threaded cap which screws onto speedo output from OD; shorter shaft has male threads onto which cable connects. At the rear of the shorter shaft I am missing cap/seal/plug which covers gear end. Anybody have one? source?
Can I disassemble, clean and lube this unit without damaging it?

thanks

REPLY TO THIS MESSAGE

SAVE

right angle drive part 120-130

posted by chakra on Wed Apr 20 15:40 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS]

[IGNORE ALL POSTS]

last visit: Sat Feb 7 10:17 CST 2009

[RELATED]

If I understand your question correctly you are talking about a black rubber seal. I am not sure the part has one at that location. There is a seal at the connection to the overdrive, but I don't see the value of a seal at the connection to the speedometer cable. It has been a while since I worked with this part, so I may be wrong.

REPLY TO THIS MESSAGE

SAVE

right angle drive part 120-130

posted by Danny on Wed Apr 20 16:30 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS]

[IGNORE ALL POSTS]

last visit: Mon Oct 6 22:01 CST 2014

[RELATED]

Maybe I wasn't clear enough. I'm talking about the aft end of the male threaded end (speedo cable connects to the threads). It looks like there was some sort of cap/plug which covered the gear end of the shaft and located/centered it. There are 3 divots in the outer edge of this end which may have pinched the rim and held the cap in. I uploaded a picture to the gallery. I can't figure out how to include it in this post.

http://www.brickboard.com/GALLERY/images/4797.jpg

<< < > >>

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.