Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2018 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

high idle 900 1991

hey guys,
I cleanded my trottle body on my 940 and now it s seams to be stuck on high I reset all the senors but I cant figure out what wrong can you guy help.
Thanks
Randy G
91'
940 SE








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    high idle 900 1991

    When I cleaned mine, I had the same problem.
    It wasn't until someone else looked and found that the wire string in the pulley was out of alignment , so once this wire was loosened by unraveling it from where it shouldn't be, the idle realxed too. Hope this helps.








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    high idle 900 1991

    High? If it runs around 1500 rpm, then you've either left the Throttle Position Sensor disconnected, you altered the TPS setting, or it broke. See the FAQ for information on TPS.

    You might also have damaged an air intake hose, leading to a vacuum leak.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.