Volvo RWD 444-544 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2005 444-544 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

544 drive shaft center support bearing gromet 444-544

I recently crawled under my 544 to investigate a sound ive been getting and found i need new "gromets" or bushing for the center support bearing. I ordered them from Swedish classics and just recieved them. Which way do they go? Thick side forward? any help would be great thanks








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    544 drive shaft center support bearing gromet 444-544

    Abram: flat side forward. And why not check the center suppoet bearing while you're down there? All best--Nathan








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      544 drive shaft center support bearing gromet 444-544

      I put them in thick side forward. Not because that is the way they are supposed to go, but because mine tend to pop out of their holder occasionally and installing them that way means they then just dangle there instead of falling off, never to be seen again.
      --
      I'm JohnMc, and I approved this message.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.