Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 5/2005 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Can I substitute a mechanical temp gauge? 200 1986

posted by  someone claiming to be Craig on  Wed Nov 15 02:42 CST 2000 [RELATED]

Can I substitute a mechanical temp gauge in place of the erratic often times non-functioning dash gauge? I've traced and tracked & need to move on to other more important fix's. Simple question: All I need to know is if I can substitute a generic mechanical temp gauge in place of the Volvo equipment without some unforeseen problem.

Thanks a bunch.







  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Re: Can I substitute a mechanical temp gauge? 200 1986

    posted by  someone claiming to be guy w on  Wed Nov 15 05:14 CST 2000 [RELATED]

    I faced the same problem 6 months ago. I was able to replace my temp compensation board, got it from Swedish Engineering for $38. My temp gauge now works great. I think replacing the board is easier and a better solution. The board is located behind the fuel/temp gauges. You must remove the back cover to get to it. Be sure to mark all wires before removing them so you can replace them correctly. I have been told you can fry your instrument cluster if you don't. Also be careful installing the board so you line up the small contacts without bending them. Swedish Engineering can probably walk you through the procedure if you need further help. I have also heard the Bentley manual has a good description, although I was able to do it without it.







  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Re: Can I substitute a mechanical temp gauge? 200 1986

    posted by  someone claiming to be Roy p., formerly Roy P. on  Wed Nov 15 03:56 CST 2000 [RELATED]


    Before condeming the volvo gauge, there are a few things you should check.

    1. The wiring to the sending unit.

    2. The temp. compensating board that's on the inst. cluster. It plugs into

    back of the cluster.The contacts get dirty and the gauge act's up.

    Also check the FAQ section :

    http://brickboard.com/FAQ/700-900/EngineSensors1.shtml#Electrical: Engine Sensors, Etc







    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Re: Can I substitute a mechanical temp gauge? 200 1986

      posted by  someone claiming to be Craig on  Wed Nov 15 04:50 CST 2000 [RELATED]

      Hi Roy,

      I've had the gauge panel out - can you tell me, or describe what the temp compensating board looks like on the '86 240?

      Thanks a ton.







      •   REPLY TO THIS MESSAGE    PRINT   SAVE 

        Re: Can I substitute a mechanical temp gauge? 200 1986

        posted by  someone claiming to be Don Foster on  Wed Nov 15 10:28 CST 2000 [RELATED]


















<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.