Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 7/2008 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Rent rear trailing arm tool? 200 1984

posted by  someone claiming to be Hank on  Thu Nov 9 12:36 CST 2000 [RELATED]

I'd like to rent a rear trailing arm tool to do the bushings. Any one have one?







  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Re: Rent rear trailing arm tool? 200 1984

    posted by  someone claiming to be Duane on  Thu Nov 9 16:56 CST 2000 [RELATED]

    I rent the tool and the 36 mm socket to drive it. Comes complete with instructions.

    $35 plus shipping.

    At present it is in Washington State. If I do not hear from the two others who asked about it but have not replied further, as soon as it gets back I can ship it to you.

    Duane







    •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

      Re: Rent rear trailing arm tool? 200 1984

      posted by  someone claiming to be Hank Auderer on  Fri Nov 10 03:42 CST 2000 [RELATED]

      Duane,

      Yes, I would most like to rent the tool. Is it the factory tool? I'll have time to do the bushings in two weekends from now if you can get it to me by then.

      Hank Auderer

      San Antonio

      hank@rivercitysilver.com







  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Re: Rent rear trailing arm tool? 200 1984

    posted by  someone claiming to be Keith Hendrickson on  Thu Nov 9 14:49 CST 2000 [RELATED]

    Hank---Just an idea....I've done the bushing thing three times now, and I've managed to replace the big ones with just a hammer. The old bushings were always so far gone I just mashed them with a chisel to get them out....then the new ones went in with lots of tapping and some grease. Keep an eye on the mounts so they don't bend over too far...a little more tapping will bring them back to where they belong. (Tedious, but it works for me.) I took the removable parts to a shop with a press....costs me $35 to have those done.

    Good Luck

    Keith






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.