Deoxit-D would be a best bet for low DC volt signal wire harness connectors. Napthalene and ? It is dielectric. Use at the wire harness connector ends both sides. You can get the concentrate and dilute in a small spray bottle.
High Voltage corrosion-inhibiting greases carrying metal abrasives can cause shorts across small signal and low volt dc power connector pin positions. Very difficult to clean out of the connector also! Stuff like that or NoOx or DeOX are conductive and used on un-tinned (usually dry, covered) bonded contacts (mmmm-mmmm, ground bars!) more so for connections exposed to weather.
Though okay to clean with a does not shred nylon scrubby or teeny pipe or bottle cleaner brush for some abrasive action. Little brushes that withstand exposure to the stuff with solvent.
--
Give your brickboard.com a big thumbs up! Way up! - Roger Ebert & Gene Siskel
|