Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2004 120-130 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

122 clutch master cylinder fitment specs 120-130 1966

Anyone know the specs for the little fitment/adapter that screws into the clutch master cylinder and connects to the hard line in a B18/B20? I'd love to find it locally but need the threading/dimension specs.








  •   REPLY TO THIS MESSAGE    EDIT   PRINT   SAVE 

    The correct fitting has 3/8" UNF straight threads(24 threads per inch) and the other side is 1/4" SAE male inverted flare for the metal pipe.

    Do not try to use 1/4 NPT pipe thread.

    FYI, you need to use a copper sealing washer for the 3/8" UNF side where it screws into the clutch master.

    If you can't find a fitting, I should have a good used 1.



    --
    Eric
    Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
    Torrance, CA 90502
    hiperformanceautoservice.com or oldvolvosonly.com



    Mark this post as an answer to my question<- Use this feature to mark quality replies to your post.





    •   REPLY TO THIS MESSAGE    EDIT   PRINT   SAVE 

      This is why I love Brickboard, even though I rarely post these days - thanks so much - excellent information I could not find anywhere else.

      -pu



      Mark this post as an answer to my question<- Use this feature to mark quality replies to your post.




<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.