Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2021 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

122 clutch master cylinder fitment specs 120-130 1966

posted by  planetman on  Sun Apr 24 13:13 CST 2022
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:29 CST 2014
[RELATED]

The correct fitting has 3/8" UNF straight threads(24 threads per inch) and the other side is 1/4" SAE male inverted flare for the metal pipe.

Do not try to use 1/4 NPT pipe thread.

FYI, you need to use a copper sealing washer for the 3/8" UNF side where it screws into the clutch master.

If you can't find a fitting, I should have a good used 1.



--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502
hiperformanceautoservice.com or oldvolvosonly.com






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 122 clutch master cylinder fitment specs [120-130][1966]
posted by  panchourbano  on Sat Apr 23 23:06 CST 2022 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.