Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

the old water pump r and r trick on a 2.2 4cyl 200 1992

posted by  porkface on  Sun Nov 22 12:05 CST 2020
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:12 CST 2014
[RELATED]

when doing the pump, i glue the gasket to the pump, let it dry, smear the block with a little grease, check the head for corrosion or pitting, a little silicone lube, not sealer, same with the o ring for the heater pipe. hang the pump to the block with 2 bolts, attach the pipe, don't tighten. with the largest dowel you can find, tighter the better, lever the pump to the head. tighten the pump bolts, criss cross. tighten the heater pipe. hepu or graf for the pump and a 1336255 seal from the dealer, the others have ALWAYS given me trouble right away or far sooner then the pumps failure. this assumes it's a 2.3, not a 2.2. good luck, chuck.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 the old water pump r and r trick on a 2.2 4cyl [200][1992]
posted by  oldduke  on Sun Nov 22 10:39 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.