Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

A question about testing fuel injectors 200 1989

uid 27's pic
posted by  Art Benstein on  Thu Oct 29 04:49 CST 2020
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

Using the OBD mode 3 test of the actuators, you can check the flow of an individual injector by removing the electrical plug from those you are not testing. Remember to replace the ECU grounds removed at the fuel rail bolts.

Don't crank or run the engine, just the residual pressure in the rail will be plenty. If you want to ensure regulated fuel pressure, operate the fuel pumps only using a jumper at the fuse panel.





--
Art Benstein near Baltimore

When the smog lifts in Los Angeles, U. C. L. A.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New A question about testing fuel injectors
posted by  OwenF  on Wed Oct 28 14:38 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.