Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Problem SOLVED! 200 1992

Thanks for the info.
I used regular BC/Vishay caps I had lying around. Industrial quality (formerly Philips), but non low-ESR.
The board is a good quality one. I had no delaminating issues whatsoever, twice as I had replaced the cap in the -561 too. The lead containing solder helps too.
However, the PCB of the -561 looked immaculate, the pcb of the -949 a little bit less so. Still good quality, but I could see some touching up had been done during manufacturing/QC.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 2 245 correct idle after start but high after use [200][1992]
posted by  Grey245  on Sat Oct 3 02:51 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.