Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

End of wire repairs 200 1991

posted by  Amarin on  Mon Sep 4 10:29 CST 2017
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 22:42 CST 2014
[RELATED]

If you're using Bougicord wires, end of wire repairs are easily done.

Slowly pull wire out of boot (to prevent any more internal breakage), undo the terminal's crimp, remove the wire's metal conducting bit, cut off the defective wire, re-insert the metal conducting bit at new wire's end, check conductivity with voltmeter, if good then re-crimp (simply using pliers) and push back terminal end into boot (with some lubricant such as dielectric grease) and its done.

Regards,
Amarin.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Arcing from coil wire to side terminals [200][1991]
posted by  UlisKeeper  on Tue Aug 22 19:19 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.