Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2004 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Clutch Slave Improper angle 120-130

posted by  TR Conn on  Sat May 6 13:16 CST 2017
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:32 CST 2014
[RELATED]

My clutch pedal has always (3 years) been a little rough and recently it started leaking a bit.
On inspection the clutch actuating rod comes out of the slave cylinder at an angle.
I don't see any way to remedy the situation other than elongate the bolt holes so it can rotate up.
Is this an accepted practice? Or did I just get an improperly made slave cylinder?
Or could it be a bent clutch fork? (unlikely, it doesn't look bent)
Thanks,
-TR





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Clutch Slave Improper angle [120-130]
posted by  TR Conn subscriber  on Sat May 6 13:16 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.