Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2012 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Next!! 940 no start/intermittent start/cold or hot 900

posted by  spook on  Sun Oct 16 21:08 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 08:06 CST 2014
[RELATED]

Dear bynks@hotmail.com,

Hope you're well. Code 1-2-2 on Port A2 (fuel injection) means the IAT (intake air temperature sensor) signal is absent or faulty. If so, this car uses Rex/Regina engine/fuel management. The IAT sensor is mounted in the cylindrical unit between the air box and the corrugated rubber hose, that takes air to the throttle body.

The sensor's two-pin wiring harness connector housing is bright blue and the sensor's body is made of black plastic, with a series of small round holes on either side. This item is part #1389556. The cost is about $65.

Before replacing this sensor, use an aerosol corrosion-remover, e.g., Deoxit to clean the sensor's pins and the wiring harness connector contacts. If cleaning does not restore smooth operation, the sensor may be defective.

Hope this helps.

Yours faithfully,

Spook






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Next!! 940 no start/intermittent start/cold or hot [900]
posted by  someone claiming to be bynks@hotmail.com  on Sun Oct 16 19:28 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.