Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

hot oil smell at rear wheel well 200 1988

posted by  maplebones on  Wed Aug 5 19:36 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 22:53 CST 2014
[RELATED]

Hi Trichard,

On any axel I've pulled on a 240, with either the old style 2 piece or newer style one piece bearing, the cup has always remained in the axel housing and the bearing is fully exposed.

If you pull the outer seal back a little bit, it's a simple matter of washing out the old grease and replacing it.

I don't understand how this is not is not practical. In the last year I've repacked an 88, 89 and 91, but maybe there are later models using sealed bearings that don't come apart on removal. I haven't seen any like that.

Peter






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New hot oil smell at rear wheel well [200][1988]
posted by  tbb2 subscriber  on Tue Aug 4 15:58 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.