Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2010 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Hesitation,Bucking after seal change 700 1990

Changed front three seals on my 1990 740GL B230F Regina system, 201,000 miles. Ran great for 150 miles now after I drive 5 miles or so it hesitates and bucks badly. Diagnostics says idle air control valve closed, I have no idea to relevance. Car ran fine until I did the seals.
--
John Bonini








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Hesitation,Bucking after seal change 700 1990

    If it won't idle, sounds like diagnostics indicates the idle control air valve. If so, take it out and clean it with electronic throttle body cleaner and see if it unsticks.








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Hesitation,Bucking after seal change 700 1990

    I don't know but that's quite a few miles, I would NOT assume the two are related. Did you check the IAC for open/close function?
    --
    '89 240 wagon, '90 740 sedan, '92 740 wagon








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Hesitation,Bucking after seal change 700 1990

    If you confirmed that you didn't knock anything loose. I would see if it jumped time.
    --
    Post Back. That's whats makes this forum work.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.